MSI 6741 DRIVER

Hardware Setup Hardware Setup This chapter tells you how to install the CPU, memory modules, and expansion cards, as well as how to setup the jumpers on the mainboard. If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. You must configure second hard drive to Slave mode by setting the jumper accordingly. Make sure to raise the lever up to a 90degree angle. Then push it in until the golden finger on the memory module is deeply inserted in the socket. The plastic clip at each side of the DIMM slot will automatically close. Avoid clearing the CMOS while the system is on; it will damage the mainboard.

Uploader: Maukasa
Date Added: 24 August 2009
File Size: 17.17 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 54586
Price: Free* [*Free Regsitration Required]

Look for the gold arrow. The connector location and pin assignments are as follows: You can clear CMOS by shorting pin while the system is off.

Always consult the vendors for proper CPU cooling fan. Each lever can be pressed down in only ONE direction. The gold arrow should point towards the lever pivot. Mic is a connector for microphones. Memory modules can be installed in any combination as follows: When you are installing the CPU, make sure the CPU has a heat sink and msii cooling fan attached on the top to prevent overheating.

  BROADCOM CORP NETLINK BCM5906M FAST ETHERNET PCIE DRIVER DOWNLOAD

If the mainboard has a System Hardware Monitor chipset on-board, you must use a specially designed fan with speed sensor to take advantage of the CPU fan control.

J9 Optional You can connect a joystick or game pad to this connector.

It supports a three-pin head connector. As the CPU is likely to move while the lever is being closed, always close the lever with your fingers msii tightly on top of the CPU to make sure the CPU is properly and completely embedded into the socket.

Avoid clearing the CMOS while the system is on; it will damage the mainboard. Mount the fan on 67441 of the heatsink. Locate the CPU and its retention mechanism on the motherboard. The module will only fit in the right orientation. The third PCI slot supports 2 master devices.

MSI Ms K8mm-ilsr Ver 1 Socket Motherboard With BP | eBay

Msu doing the installation, be careful in holding the components and follow the installation procedures. Then push it in until the golden finger on the memory module is deeply inserted in the socket. Also, it provides the instructions on connecting the peripheral mwi, such as the mouse, keyboard, etc. You can attach a serial mouse or other serial devices directly to the connector. You can plug the USB device directly into the connector. Getting Started Chapter 1.

  AVERMEDIA 23888 DRIVER DOWNLOAD

MSI MS-6741 Manuals

If you install two hard disks on cable, you must configure the second drive to 671 mode by setting its jumper. Please note that any violation of the correct installation procedures may cause permanent damages to your mainboard. Position the heatsink onto the retention mechanism.

Then push down the power supply firmly into the connector. You must configure second hard drive to Slave mode by setting the jumper nsi. The CPU can only fit in the correct orientation. If the CPU is correctly installed, the pins should be completely embedded into the socket and can not be seen. It introduces a 66MHz, bit channel for the graphics controller to directly access main memory. You can install either single- or double-sided modules in any order to meet your own needs. Follow the instructions below to clear the data: You can barely see the golden finger if the module is properly inserted in the socket.